Compile-without-sercomm » History » Revision 8
« Previous |
Revision 8/12
(diff)
| Next »
Anonymous, 02/19/2016 10:49 PM
NuttX compilation was done using CodeSourcery arm-2010.09-51-arm-none-eabi.bin, other toolchain could fail.
NuttX can be configured differently depending on what we want.
The possible configs are:
* compal_e88/nsh_highram : for the gta02 using the osmocon for the romloader
* compal_e99/nsh_highram : for the c155 using osmocon + loader.compalram.bin as a loader
* compal_e99/nsh_compalram : for the c155 using osmocon to load it
nsh is the nuttx shell(nuttx can also run standalone apps without a shell).
standalone nuttxif you want a standalone nuttx(without linking to osmocombb for the drivers) do the following: {{{
make clean
make distclean
}}}
Remove sercomm directories:
{{{
$ rm -rf drivers/sercomm
$ rm -rf include/nuttx/sercomm
}}}
Remove sercomm reference at drivers/Makefile:
{{{
-include sercomm/Make.defs
}}}
Then configure nuttx:
{{{
$ cd nuttx/tools
$ ./configure.sh compal_e99/nsh_highram
}}}
Then apply manually the following pseudo-diff in nuttx/.config :
{{{
-CONFIG_SERCOMM_CONSOLE=y
+CONFIG_SERCOMM_CONSOLE=n
-CONFIG_DISABLE_ENVIRON=y
+CONFIG_DISABLE_ENVIRON=n
+CONFIG_STDIO_LINE_BUFFER=y
}}}
And then remove the following lines from nuttx/Make.defs:
{{{
OSMODIR = $(TOPDIR)/../../osmocom-bb
EXTRA_LIBS = $(OSMODIR)/src/target/firmware/comm/libcomm.a \
$(OSMODIR)/src/shared/libosmocore/build-target/src/.libs/libosmocore.a \
$(OSMODIR)/src/target/firmware/calypso/libcalypso.a \
$(OSMODIR)/src/target/firmware/comm/libcomm.a
# ^^^ Stupid hack! Why do I have to put it twice???
}}}
Compile NuttX:
{{{
$ cd nuttx
$ make
}}}
Load nuttx.bin into Motorola C155, because nuttx.bin is bigger than 64k, you should load chainload.compalram.bin together, use this command:
{{{
./osmocom-bb/src/host/osmocon/osmocon -p /dev/ttyUSB0 -m c155 /osmocom-bb/src/target/firmware/board/compal_e99/chainload.compalram.bin -c nuttx.bin
}}}
Updated by about 8 years ago · 8 revisions