HFC-E1 » History » Version 1
laforge, 02/19/2016 10:47 PM
1 | 1 | laforge | |
---|---|---|---|
2 | The HFC-E1 is an E1 controller chipset for PCI bus, produced by ChipCologne. |
||
3 | |||
4 | ChipCologne offers a HFC-E1 Evaluation Board, which is used by our project. |
||
5 | Other HFC-E1 cards should theoretically work, too - although this has not |
||
6 | been tested. The card has to support 120Ohms NT mode. |
||
7 | |||
8 | == Hardware configuration == |
||
9 | |||
10 | We set the Jumper and termination configuration as follows: |
||
11 | * 120 Ohms Termination |
||
12 | * 1: off |
||
13 | * 2: on |
||
14 | * TE Mode Config A (Pin1/2: Rx, Pin 4/5: Tx) |
||
15 | * All JP6 and JP1 jumpers between pins 1 and 2 (left) |