HFC-E1 » History » Version 3
Anonymous, 02/19/2016 10:47 PM
1 | 1 | laforge | |
---|---|---|---|
2 | 2 | laforge | The HFC-E1 is an E1 controller chipset for PCI bus, produced by CologneChip. |
3 | 1 | laforge | |
4 | 3 | laforge | There are a number of cards using this chipset, among others |
5 | * The HFC-E1 Evaluation Board of ChipCologne |
||
6 | * Beronet BN1E1 Card (http://www.beronet.com/downloads/whitepapers/BNXE1.pdf) |
||
7 | * Junghanns.NET SingleE1 card (http://www.junghanns.net/en/singleE1_produkt.html) |
||
8 | |||
9 | == Evaluation Board == |
||
10 | |||
11 | 1 | laforge | CologneChip offers a HFC-E1 Evaluation Board, which is used by our project. |
12 | Other HFC-E1 cards should theoretically work, too - although this has not |
||
13 | been tested. The card has to support 120Ohms NT mode. |
||
14 | |||
15 | 3 | laforge | === Hardware configuration === |
16 | 1 | laforge | |
17 | We set the Jumper and termination configuration as follows: |
||
18 | * 120 Ohms Termination |
||
19 | * 1: off |
||
20 | * 2: on |
||
21 | * TE Mode Config A (Pin1/2: Rx, Pin 4/5: Tx) |
||
22 | * All JP6 and JP1 jumpers between pins 1 and 2 (left) |