Actions
Bug #1431
closeduse PA16 for UDP_PUP as required by SAM-BA
Start date:
Due date:
% Done:
0%
Spec Reference:
Description
The AT91SAM7 manual explicitly indicates in "21.6 Hardware and Software Constraints" that PA16 should be used for the USB pull-up function.
Theh PA30 that we're using is not working, i.e. it remains high after reset, pulling UDP_PUP low, disabling the pull-up resistor.
Updated by tsaitgaist almost 13 years ago
- Resolution set to fixed
I wasn't aware of this constraint.
Now fixed in KiCAD (rerouting has also been done). gerber will be rendered with v1.0.
Updated by laforge about 8 years ago
- Project changed from OsmocomBB to SIMtrace
- Category changed from 244 to SIMtrace hardware
Actions